Table of Contents
Advertisement
9.11 Termination
To avoid interference the last unit of a DMX-
chain should be terminated. Therefore the
DIP switch (9) of the last unit in the DMX-
chain must be switched ON.
9.12 Maintenance (boot loader)
The Maintenance (boot loader) function
enables the unit to receive firmware
updates via the DMX connectors. For
further information refer to our website and
check "Download".
9.14 DMX signal condition
MODE>
A
DMX
CH1
Out1 Out1
CH2
Out2 Out2
CH3
Out3 Out3
CH4
0
PRELIMINARY
P
C
(CH3<50)
Mix
Level
0-49
0
Tact
9.12 Switch on condition
The unit always returns to the last mode
before it was switched off. In DMX Slave
"SLA" or DMX Mode "d" or DMX Preset
Mode "P" all DMX values are cleared if
power is switched off.
9.13 DMX signal condition
The device will retain the status that it
was in before the DMX signal got lost, but
potential tact settings will be automatically
cleared.
P
(CH3>50)
Pattern
Level
Speed
Tact
Level/Tact
K-CTRL
D
SLA
Out1
Out1
Out2
Out2
Out3
Out3
0
15
Advertisement
Table of Contents
