Table of Contents
Advertisement
9.2 "C" Colour Mode
Press the MODE button (5) until the first
digit on the display shows "C", indicating
operation in "C" mode. Then choose one
of the 19 presets as shown in the list below
by using the UP/DOWN buttons (6/7).
Changing the setting becomes effective
directly. Knob (1) determines the output
level.
In "C" mode, the unit does not receive any
values from the DMX input but generates
related DMX values on the output
according to the selected pattern, so that
Available colour presets:
C 0
all off
C 1
Out1
C 2
Out2
C 3
Out3
C 4
MixA
C 5
MixB
C 6
MixC
C 7
MixD
C 8
MixE
C 9
MixF
9.3 "SLA" DMX Slave Mode
Press the MODE button (5) until the
display shows "SLA", indicating operation
in "SLA" (SLAVE) mode. In this mode the
unit is set to DMX-channel 001 in order
to receive the signals from a master unit
of the Multiform LS series being in mode
"A" or "C". The unit interprets CH1 as
Out1 level, CH2 as Out2 level and CH3
as Out3 level. CH4 is not in use, and the
potentiometer (1) is disabled.
PRELIMINARY
other similar units from the Multiform LS
series can show the same behaviour if
they are connected by DMX signal cables
and set to Slave Mode "SLA".
NOTE: The "C" Mode is automatically
disabled and cannot be chosen when an
external DMX signal is received [DMX
indicator LED (3) is lit].
If you leave mode "C" for any reason and
come back later into mode "C", the unit will
recall the last chosen mix (even if the unit
was switched off in between).
C10
MixG
C11
MixH
C12
MixI
C13
MixJ
C14
MixK
C15
MixL
C16
MixM
C17
MixN
C18
MixO
C19
All outputs full on
similar units from the Multiform LS series
can show the same behaviour if they are
connected by DMX signal cables and set
to Slave Mode "SLA".
NOTE: The "C" Mode is automatically
disabled and cannot be chosen when an
external DMX signal is received [DMX
indicator LED (3) is lit].
If you leave mode "SLA" for any reason
and come back later into mode "C", the
K-CTRL
11
Advertisement
Table of Contents
