Understanding Display Messages - Samsung SCX-4300 User Manual

Understanding display messages

Messages appear on the Smart Panel program window or the
control panel display to indicate the machine's status or errors.
Refer to the tables below to understand the messages' meaning
and correct the problem if necessary. Messages and their
meanings are listed in alphabetical order.
N : When you call for service, it is very convenient to tell
OTE
the service representative the display message.
Display Meaning
Door Open The front cover
or rear cover is
not securely
latched.
Hsync Error A problem has
occurred in the LSU
(Laser Scanning
Unit).
Invalid Toner You have used an
unauthorized
cartridge.
Jam 1 or Install • The toner
Toner
cartridge is not
installed.
• Paper has
jammed in the
fuser area or in
the manual
feeder.
Low Heat Error There is a problem
in the fuser unit.
[LSU Error] A problem has
occurred in the LSU
(Laser Scanning
Unit).
[No Paper] The paper in the
paper input tray
Add Paper
has run out.
Open Heat Error There is a problem
in the fuser unit.
[Over Heat] There is a problem
in the fuser unit.
Suggested solutions
Close the cover until it locks
into place.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
You must use a Samsung
approved cartridge.
• Install the Samsung genuine
toner cartridge designed
for your machine. Otherwise
reinstall toner cartridge at
several times. See page 2.2.
• Clean the paper jam. See
page 9.1.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Load paper in the paper input
tray. See page 2.3.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Troubleshooting
Display
[Paper Jam 0] Paper has jammed
in the feeding area
Open/Close
of the paper
Door
input tray.
[Paper Jam 1] Paper has jammed
Open/Close in the fuser area or
Door in the manual
feeder.
[Paper Jam 2] Paper has jammed
Check Inside in the paper exit
area.
Power Failure Power has turned
off then on and the
machine's memory
has not been back
up.
Scanner Error There is a problem
in the scanner unit.
Toner Empty The toner cartridge
Replace Toner has run out.
Toner To prevent serious
Exhausted pollution or
Replace Toner breakdown of
printer, the printer
stops printing.
Toner Low The toner is almost
empty.
NonSamsung The toner cartridge
Toner Replace is not a Samsung-
Toner genuine cartridge.
9.4
Meaning Suggested solutions
Clear the jam. See page 9.1.
Clear the jam. See page 9.1.
Clear the jam. See page 9.2.
The job which you were trying
to do before the power failure
must be completely re-done.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Replace the toner cartridge with
a new one. See page 8.4.
Replace the toner cartridge with
a new one. See page 8.4.
Take out the toner cartridge
and gently shake it. By doing
this, you can temporarily
reestablish printing operations.
Replace the toner cartridge with
a Samsung-genuine.