SAMSUNG SCX‐4300 ALL IN ONE PRINTER
FIRMWARE INSTALLATION INSTRUCTIONS
This Firmware only needs to be installed ONCE. If the printer already has the Firmware 1.18fix installed, it
is OK just to replace the used cartridge with a new remanufactured cartridge and chip. If your printer has
1.18fix installed, go straight to Paragraph G
STARTING POINT
The printer is saying: TONER EMPTY, REPLACE TONER. It will not print
BEFORE YOU PROCEED, PLEASE NOTE THE FOLLOWING:‐
1. Before installing this Firmware, you must ensure that the printer is in ORIGINAL condition and has not
been modified, particularly on the motherboard.
2. The computer must already have in it the DRIVERS for SCX‐4300 printer and scanner
3. The computer should only be connected to the printer. All other USB devices MUST be disconnected.
4. The replacement cartridge with our chip should be installed in the printer and cover closed.
5. The power to the printer should be ON throughout the installation.
6. WINDOWS XP/ WINDOWS 2000 can read the CD automatically.
WINDOWS VISTA needs to be in ADMINISTRATOR mode to run the CD.
(Open the CD, RIGHT CLICK on "cdrun" then select "run as ADMINISTRATOR")
7 It is recommended to close the AntiVirus software on your computer until the installation is complete
(the AntiVirus software often mistakes the driver for a Type32 virus and this is not correct)
8. Start the printer and make sure it has finished its initial routine – red lights ON!
Samsung SCX‐4300 | Firmware Installation
1