Depth Tolerance; Brake Depth - Taurox 120 User Manual

120 - 300 / 400 / 900
Abort after a faulty workpiece
confirming the start button in case of an error after finishing the
machining of the part.
The machining is blocked after the last thread of the part.
The display shows the following message in parameter area C13
workpieces
threads per workpiece
reset
When the number of parts has been reached, the display shows
Display while processing:
C10 C11 C12

4.4.5.4 Depth tolerance

Option: off / on
You can set the depth tolerance from
(See chapter: "Quality messages")

4.4.5.5 Brake depth

Option: off / automatic / manual
Machine calculates brake depth during processing. This is necessary for
careful processing. Due unfavorable processing parameters (eg, low
torque, high speed, high pitch), depth can be exceeded. Avoid this by
changing the processing parameters, or adjusting the brake depth.
- off
- automatic
- manual
-set quantity (1 – 32000)
– set (1 – 250)
of counted workpieces
. This message must be reset by confirming the start button.
C10 Workpiece counter active
3 1256 15
1 2
C11 Workpiece counter (number of pieces)
C12 Thread counter per part (number of
brake depth is off (eg for applications with high
processing sequences of through threads).
brake depth is automatically calculated by the machine
during processing.
brake depth can be adjusted manually in low processing
parameters.
- The last part must be reset by
pieces)
0 mm – 6 mm.
user manual
37