Envirovent energiSava 250 Installation Manual page 2

Safety
Read and understand these instructions carefully before
beginning installation. The unit should only be installed by a
competent person.
Electrical Connection
The unit requires a continuous electrical power supply. Connection to
the fixed wiring must be made outside the unit in a suitable location.
The unit must be able to be disconnected from the mains supply
after installation. The unit must be earthed and a suitable isolator
having a minimum contact separation of 3.0mm must be used to
provide isolation for the unit.
The power cable running into the unit must remain the supplied
flexible cable. If the power cable becomes damaged, it must be
replaced by EnviroVent, an authorised service agent for your region/
country, or a similarly qualified person in order to avoid a hazard. Do
not remove or tamper with any electronic components inside the
unit.
All wiring must comply with Building Regulations and the current
IET Wiring Regulations (BS7671 in the UK) or equivalent standards for
other countries. The final installation should be examined and tested
by a qualified electrician.
The unit is considered to be suitable for use in countries having a
warm, damp equable climate. It may also be used in other countries.
2
energiSava 250
®
SHOULD YOU ENCOUNTER ANY PROBLEMS
INSTALLING THIS UNIT, CALL US ON:
01423 859 395