Table of Contents
Advertisement
3.3.7
Buttons / LED
On the module, there is a pushbutton SW1 (RESET), which must be used to restart the module. This is connected to the EN signal of the ESP32-WROVER.
There are also four LEDS onboard.
White LED (POWER ON) shows when the module is powered.
Blue LED (EDGEHOG) shows if the device is connected to EDGEHOG Cloud.
Yellow LED (ACTIVITY) shows WiFi/BT activity or various types of reports.
Green LED (MODEM)
SENSE D47
D47 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.3 - Author: LM - Reviewed by SB & LP & GL Copyright © 2020 SECO S.p.A.
LTE Antenna Jinchang Electron JCG108L
Frequency Range
Polarization
Gain (Zenith)
V.S.W.R(min)
Impedance
GPS Active Antenna Jinchang Electron JCA002
Frequency Range
Band Width
Polarization
Gain (Zenith)
V.S.W.R(min)
Impedance
Axial Ratio
698~960/1710~2690MHz
Linear
2.0dBi
<2.5
1575.42±3MHz
CF±5MHz
RHCP
2.0dBic
<1.5
3 dB (max)
21
Advertisement
Table of Contents
