Seco SENSE-D47 User Manual page 16

3.1 Introduction
On SENSE-D47 board, there are several connectors located on the lower and upper part of the enclosure. Moreover, there is a hardware reset button and three
LEDs for activity, modem and EDGEHOG connection.
Battery Switch
Please be aware that, depending on the configuration purchased, the appearance of the system could be slightly different from the above pictures.
SENSE D47
D47 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.3 - Author: LM - Reviewed by SB & LP & GL Copyright © 2020 SECO S.p.A.
SMA1 uSD Card
Power Port P1 Can Bus Port
P5
SMA2
GPIO Port P4
SMA3
LEDs
Reset Button
Serial Port P6
16