DSI Dynamatic AS-703 Instruction Manual page 2

DANGER HIGH VOLTAGE
Motor control equipment and electronic controllers are connected to hazardous line voltage. When servicing
drives and electronic controllers, there may be exposed components with their cases and protrusions at or
above line potential. Extreme care should be taken to protect against shock. Stand on an insulating pad and
make it a habit to use only one hand when checking components. Always work with another person in case
an emergency occurs. Disconnect power whenever possible to check controllers or to perform maintenance.
Be sure equipment is properly grounded. Wear safety glasses whenever working on an electronic controller
or electrical rotating equipment.
CAUTION:
Rototating shafts and above ground electrical potentials can be hazardous. Therefore, it is strongly
recommended that all electrical work conform to National Electrical Codes and local regulations. Installation,
alignment and maintenance should be performed only by qualified personnel.
Factory recommended test procedures, included in the instruction manual, should be followed. Always
disconnect electrical power before working on the unit.
REFER TO OSHA RULES AND REGULATIONS, PARAGRAPH 1910.219 FOR GUARDS ON MECHANICAL
POWER TRANSMISSION APPARATUS.
Note - Since improvements are continually being made to available equipment, the enclosed data is subject
to change without notice. All drawings, unless certified, are for reference only. For additional information,
contact DSI/Dynamatic® at 1-800/548-2169 or 262/554-7977.
The printed contents in this instruction book are to be used for reference only. Due to periodic engineering
design changes and the addition of modifications, this material is provided as a guide only.
Refer to the enclosed engineering drawings, which are furnished for your specific unit.
For additional information regarding contents of this manual, please send your request to DSI/Dynamatic®,
Fax: 262-554-7041, or call: 262/554-7977, or Toll free at 1-800/548-2169.
This notice is provided to clarify the intent of the instruction book contents and to inform our customers how
to obtain appropriate technical assistance from the proper source.
©Copyright DSI/Dynamatic®, 2019
2
IMPORTANT NOTICE