Advertisement
network. The Status LED will blink steadily when a station has been
added to the network and configured.
*NOTE: A new feature with Design Center 2.3 and up is the ability
to configure RadioLink stations the same way WireLink stations are
configured, e.g., 3-button press. When configuring stations, if the
Exclude RadioLink Bus check box, under Settings | System
Preferences, is not checked, all RadioLink stations go back to non-
programmed mode when the Configure Stations button on the tool
bar is clicked. The station's LEDs will all blink while in configure
station mode. After configuring stations and clicking the Configure
Stations button again to turn configure stations mode off, all
RadioLink stations need to log back on to the system before
working as programmed. Allow time for this to occur.
Diagnostic and Test Information
Each contact input has an actuator button and 2 status LED's. The
actuator button shorts the input to ground. The Contact State LED
Line Drawings
NOTE: RadioLink Model – Top Label; Power Input Connection is
15-36VDC or 12-28VAC, 250mA IN
©Vantage, 1/3/2017 / IS-0584-B
DIN WireLink and RadioLink CIS — MODEL: CIS10-DIN & STIDER121
illuminates when the contact input is grounded. The Program State
LED operates the same as switch LEDs on a keypad station. When
grounded, Contact States trigger the Program State ON or OFF
depending on whether the contact's polarity is set to Normally
Open or Normally Closed.
The Status LED blinks steady on and off for 1, 2, 3 or 4 blinks
followed by a pause.
One Even Blink:
CIS is operating correctly and is configured.
Two Blinks:
CIS is operating correctly but is not configured
(wired model).
Three Blinks:
CIS is not communicating with the Main
Controller, verify station bus wiring or if
RadioLink it is not yet configured.
Four Blinks:
Factory problem. Please contact the factory.
Five blinks:
Configuration mode.
RadioLink Model FCC Information
This device contains transmitter module:
FCC ID: PII-VSUB075-1 or PII-VSUB235
IC ID: 3505A-VSUB0751 or 3505A-VSUB235
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to this product not expressly approved by
Vantage Controls could void the user's authority to operate this product.
Side
Label
Enlarged
I N S T A L L A T I O N
(1) This device may not cause harmful
page 2 of 2
Advertisement
