Loading Media; Loading Labels From A Roll - Brady BP-PR PLUS Series Quick Operator's Manual

BP-PR PLUS series

Loading media

6 Loading media
For adjustments and simple installation work, use the accompanying hexagonal wrench located in the
bottom section of the print unit. See Fig. 5, Item 8. No other tools are required for the work described
here.
6.1

Loading labels from a roll

6.1.1 Removing and installing the core adapter
A core adapter is mounted for better guidance of the label roll on the roll retainer when using label rolls
with a core diameter ≥ 75 mm. Remove core adapter for smaller label rolls as follows.
Fig. 4: Installing the core adapter
10
Removing the core adapter
1. Open cover (1).
1
2. Loosen retaining screws of core adapter (2)
3. Remove core adapter from roll retainer (4).
Installing the core adapter
1. Open cover (1).
2. Loosen retaining screws of core adapter (2)
2
3
3. Slide first core adapter onto the roll retainer
4
4. Slide second core adapter onto the roll
Quick Operator's Guide
with hexagonal wrench.
with hexagonal wrench.
(4) until it stops at the housing and tighten
retaining screw.
retainer (4) based on the roll width and
tighten retaining screw.
Edition 7/06