Receipt,Storage And Handling; Operating Conditions; Table 1: Controller Packing List; Table 2: Permitted Ambient Temperatures - Lorentz PS15k2 C-SJ42-6 Manual

4 Receipt,Storage and Handling

Table 1: Controller packing list

# Item
1 PSk2 controller
2 Key for front door
3 Mini plug for accessories
4 Sun Switch module 1.5 Wp
Check on receipt that the packaging is undamaged and
complete. If any abnormity is found, contact your distribu-
tor. Check you delivery according to the following table.
LORENTZ pumps are supplied from the factory in proper
packing in which they should remain until they are to be
installed at the site. Handle the pump with care and avoid
unnecessary impacts and shocks.
CAUTION – Do not attempt to use
the controller for any purpose other
than LORENTZ PSk Pump Systems
Do not attempt to run the motor
without the controller
Prolonged intermediate storage in an environment of high
humidity and fluctuating temperatures must be avoided.
Moisture condensation may damage metal parts. Non-
compliance will void any warranty. It is recommended
storing the parts in a closed and dry room.
The motor, the pump end and controller can be stored
(not used) in the range of –20 °C to +65 °C (–4 °F to
+149 °F). The components should not be exposed to direct
sunlight.
If the motor is stored for more than 3 months, the rotor
must be turned by hand before use to ensure that the rotor
is not stuck.
BERNT LORENTZ GmbH & Co. KG Kroegerskoppel 7, 24558 Henstedt-Ulzburg, Germany, Tel. +49 (0) 4193 7548 - 0, Fax - 29, www.lorentz.de
All specifi cations and information are given with good intent, errors are possible and products may be subject to change without notice. Pictures may
differ from actual products depending on local market requirements and regulations.

5 Operating Conditions

Table 2: Permitted ambient temperatures

QTY Item
1 unit Controller
Pump unit (pump
1 unit
end + motor)
3 pcs Fluid temperature
1 unit
Humidity and air salinity – The pump system must not
be stored or operated where the average day humidity is
above 80 %. It should not be stored or operated within
1 km / 0.6 miles of coastal regions or in saline air (more
than 2 μg/m³).
Altitude – The pump system must not be installed at alti-
tudes above +3,000 m / +10,000 ft mean sea level (other
altitudes on request).
Fluid – PSk2 submersible pumps can be used for drinking
water supply, livestock watering and irrigation applica-
tions not containing solid or long fibred particles larger
than sand grains, with a max. grain size of 2 mm. The max.
permitted sand content is 500 ppm, a higher sand content
will reduce the pump life considerably due to wear. The
max. salt content is 300 – 500 ppm at max. 30 °C / 85 °F.
Defects due to pumping other liquids are not covered by
the warranty.
Max temperature
–30 °C to +50 °C –22 °F to +122 °F
+32 °F to +86 °F
0 °C to +30 °C
+32 °F to +86 °F
0 °C to +30 °C
5
Sun. Water. Life.