Table of Contents
Advertisement
Q7 After connecting to a TV, some programs such as Debug, Mem, etc. do not
run in full screen MS-DOS mode.
A
If a TV is used as the display device, some programs such as Debug, Mem, etc.
may not run properly in full screen MS-DOS mode. Run the programs in the MS-
DOS window.
Q8 The Taskbar on the bottom of the screen does not appear when a projector
is used as the display device.
A
This may happen, even though WXGA LCD supports the 1280x800 mode, the
projector does not support that mode. In this case change the resolution to
1024x768 (recommended) on your computer.
Q9 When a TV is connected, the Turn off monitor power option is not
performed.
A
When connecting a TV after booting up your computer, the Turn off monitor
power option may not be performed. For it to operate properly, it is recommended
to connect a TV and then booting up the computer.
Q10 The color is strange when the picture is displayed on the connected monitor
(or projector).
A
Check the monitor signal cable connection and reconnect the cable.
Q11 If I run the Catalyst Control Center of the graphics driver, it appears on the
screen after some time.
A
Since the Catalyst Control Center is developed based on the .Net Framework of
Microsoft, some time is required to define the .Net Framework settings when
launched for the first time.
Q12 I have connected a TV with a cable that converts S-Video to Composite, but
the picture is displayed abnormally on the screen.
A
This system supports connecting a TV with an S-Video or Component cable but
does not support connecting a TV through a Composite interface with a cable that
converts S-Video to Composite.
Troubleshooting 121
Advertisement
Table of Contents
