Advertisement
5. Close locking tabs on flex adapter so
tabs seat in the flex pipe. Slight adjustment
of pipe may be needed to ensure proper
engagement.
Figure 3, Flex Puller
FLEX PULLER
A flex puller is an optional component
available to help ease installation of PP
Flex through enclosures (Fig.3). The
2"(60mm) version is of different design than
3"-5"(80mm-130mm).
2" Dia: Unscrew ceramic holder from cone.
Install ceramic holder around PP Flex pipe,
and re-install into cone.
3"-5" Dia: Connected using bayonet style
connection with a rotating movement of 1/4
turn to lock in.
MASONRY / SHEET ROCK
ENCLOSURE:
Examine the chimney or enclosure
carefully for obstructions prior to starting
an installation. Any structural defects or
potential safety problems must be repaired
prior to relining, and the enclsoure should be
clean. If working with a masonry chimney
6
ROPE
that is lined with a clay or concrete liner,
check to see if a short portion of the tile is
sticking out of the top of the chimney. If so,
this short top portion must be broken off to
permit the termination's flashing to sit down
flush on the chimney's crown. It is best to do
this prior to beginning the installation.
1. Determine the required location of the
opening within the enclosure. Ensure the flue
access cut-out meets the minimum specified
size to allow manual assembly of connections
within the flue. With masonry chimneys, the
breech opening may have to be enlarged
FLEX CHIMNEY LINING KIT
1. Wall Plate
2. Support Elbow
3. Flex Chimney Support
4. Flex Male Adapter
5. Clamp (or Tie)
6. Flex Coupler
7. Gasket
8. Flex Liner
9. Spacer
10. Support Bracket
11. Flex
Female Adapter
12. Flex Chimney
Cap Flashing
13. Termination
Pipe
6
2
1
13
12
11
10
7
9
8
7
5
4
3
Advertisement
