Gree ULTRA heating GMV5 Multi VRF Series Service Manual page 87

4. Replace the pump.
5. Connect the drainage duct
and screw the new pump.
6. Install and screw the water
tray.
◆ Wall Mounted Type IDU
Step
1.Remove the louver
2.Open the front panel
3. Remove the electrical box
cover 2
1. Screw the outlet pipe
2. Screw the pump
Removal of Fan Motor
Remark: before removing, making sure power is disconnected.
Diagram
DC Inverter Side Discharge VRF Ⅱ
●Replace the pump.
●Connect the drainage duct and use a
screwdriver to screw the new pump.
Tighten the screws
●Use a screwdriver to screw the water tray.
Operation Procedure
●Take off the axle bush of the louver.
●Remove the louver.
●Hold the indents on both sides of the
panel and pull it out in the direction
shown by the arrow.
box cover with a screwdriver. Take off
the box cover 2.
●Detach the ambient temperature sensor
from the conduit.
for North America
85