Daikin UHA075B5 Catalogue/Engineering Data page 45

4. View parameters
View the parameters of the unit on the controller include EWT, LWT, hot water temperature, hot
water setting temperature, entering water setting temperature and so on, press "▲"or"▼" to view the
parameters.
5. Setting parameters
Press the "Password" key to display "PASSWORD" and "00" in the lower left box of the LCD, press
1
the "▲" or "▼" key to select the highest digit of the password, press the "Enter" key to confirm this digit
and move the password leftward; press the "▲" or "▼" key to select the next digit, till two digits are
entered; press the "Enter" key to exit the password entry interface, and the display box displays time.
When the correct user password "55" is selected (the user password can be used to change the hot
water setting temperature and inlet water setting temperature), you can perform the following settings.
The password entry status exits if there is no operation within 5s after the password is entered.
You can choose the parameter to be set by pressing the "▲" or "▼" key and then press "Enter". The
2
parameter name blinks. You can press the "▲" or "▼" key to set the parameter value, and then press
"Enter" to save the setting result.
You can repeat step
3
within 60s; to set parameters again, you need to enter the password).
Note: Parameters can be set only when the unit is off.
6. Choose temperature unit
Press "password" key for 5s, temperature unit will change between ºC and ºF, buzzer will have a short
ring when successfully choosing.
7. Setting real time
To set week and time, stick the small hole above the "Mode" key using a needle-like tool (the LCD
1
displays "WEEK SET"), indicating access to the weekday adjustment phase.
Press the "▲" or "▼" key to set the weekday of the current time.
2
Press the small button to set the weekday successfully. Meanwhile, the "CLOCK SET" text is
3
displayed and blinks on the LCD, indicating access to the time adjustment phase.
Press the "▲" key to change hour, and the "▼" key to change minute.
4
Press the small button again to save the set time.
5
Note: If the "Unit", "Password", "Timer" or "Enter" key is pressed or no key is pressed within 5s in the
time setting process, time setting will exit without saving the set time.
44
to set other parameters (note: password access will exit if no key is pressed
2