Advertisement
Fig 3. Thermostat Function:
The room temperature is measured and then compared to the set temperature.
The f lame height automatically adjusts to achieve the set temperature.
1. Select Thermostatic Mode from the left sidebar.
2. Touch the colour wheel to set the temperature. Blue is the lowest temperature
setting and red is the highest.
After touching the colour wheel, the new set temperature is shown in the middle of
the circle for approx. 3 seconds. After 3 seconds, the room temperature is shown
in the middle of the circle. An arrow either above or below the room temperature
indicates the f lame height going up or down to reach set temperature.
Fig 4. Program Mode
Each of 8 programs can be set to go ON and OFF at specific times at set
temperatures.
1. Select Program Mode from the left sidebar.
2. Turn ON desired Program (1 – 8) by touching the power button.
3. To change days, times, or ON/OFF temperature, touch the program number.
4. Touch the section of the setting wheel to be changed (time, temp, day).
Change the setting.
5. Confirm your changes by touching the yellow checkmark.
NOTE: To delete a program, touch that program number and go to program
settings. Touch red CLE A R button and then touch the red check mark.
Fig 5. Eco Wave
Save energ y while enjoying a changing, realistic f lame picture.
1. Select Eco Mode from the left sidebar.
2. Choose between low fire, medium fire, and high fire.
3. Choose time button (15 min, 20 min, or 25 min). The percentage of energ y saved
is shown in the circle/leaf.
NOTE: A shorter time cycle results in a more active flame picture.
Fig 6. AUX Double Burner Switch
Operate an additional function, e.g. a second burner.
1. Select AUX from the left or right/bottom sidebars. Additional function turns ON.
2. Touch AUX icon again and the additional function turn OFF.
Fig 7. Countdown Timer
At the end of a preset countdown time, the fire turns off.
1. Select Countdown Timer from the left or right/bottom sidebars.
2. Spin the hour wheel to set hour. Spin the minute wheel to set minutes.
3. Touch power button to start Countdown Timer.
The time remaining is shown on top of screen next to hourglass icon.
4. Touch power button to stop Countdown Timer.
NOTE: Countdown Timer only works in Manual, Thermostatic, and Eco
modes.
Fig 8. Child Lock
Renders smart device inoperable except for the OFF function and information
page.
1. Select Safety Lock from the left sidebar.
A pop-up shows user the Child Safety Lock is ON, and the Safety Lock icon
appears on the lower right quarter of the home screen's blue temperature circle.
2. To deactivate Child Safety Lock, touch the Child Safety Lock icon in the left menu
and on the lower right quarter of the blue temperature circle simultaneously for 2
seconds.
Advertisement
