Advertisement
1. THE PRODUCT
2
1.1 PRODUCT SNAPSHOT
1.2 OPERATION
The OMEGA Cylinder watch winder winds automatic
watches, keeping them charged and showing the
correct time. It can be turned on and off by simply
pressing a button. When it is switched on, the white LED
indicates the status of the batteries. The device then
positions itself vertically.
The watch winder is equipped with an infrared sensor
that detects the presence of a watch in the device. If
there is no watch in the winder, it will remain in standby
mode without draining its batteries.
1
2
3
1 Watch holder.
2 Top lid screw
(for changing the battery).
3 ON/OFF button
+ LED indicator.
A motor current control function stops the system if the
movement jams. Once the device has detected a problem,
it can only be restarted by pressing the button.
The number of rotations and the wait time can be confi-
gured using a computer interface that connects to the
device via Bluetooth. There is even an advanced mode
that also configures motor torque (which can influence
rotation speed), torque limitation and the watch detec-
tion threshold.
2. INSTRUCTIONS FOR USE
2.1 SWITCHING THE OMEGA CYLINDER ON / OFF
To switch the OMEGA Cylinder on, press the ON / OFF
button (number 3 in figure 1.1). The white LED lights up
to confirm that the button has been pressed. The LED will
remain lit while the button is being pressed. The device
will not start until the button is released. Do not press the
button for more than four seconds, as this will activate the
Bluetooth configuration mode (see chapter 3).
The device's LED flashes to indicate the status of the
batteries:
4 flashes : batteries 100% charged
3 flashes : batteries more than 60% charged
2 flashes : batteries more than 30% charged
1 flash : batteries nearly flat (<30% charged)
3
Advertisement
