Setting Your System - RSI VIDEO TECHNOLOGIES VIDEOFIED User Manual

ENGLISH

Setting your system

1. From your keypad
 Press the
 Enter your access code and press
 The keypad display will then show the following message
 The time delay starts, and short beeping sounds are emitted from the keypad
and/or remote internal sirens. At the end of the time delay the system is set.
The red light on the keypad flashes every two seconds.
2. From your remote control
 Press the
 The remote control will then beep twice in confirmation
 The time delay starts, and short beeping sounds are emitted from the keypad
and/or remote internal sirens. At the end of the time delay the system is set.
The red light on the keypad flashes every two seconds.
Part setting your system
1. From your keypad
 Press the
 Wait for the keypad display
 Enter your access code and press
 The keypad display will then show the following message
 The time delay starts, and short beeping sounds are emitted from the keypad and/or remote
internal sirens. At the end of the time delay the system enters part set mode 1.
The red light on the keypad flashes every two seconds.
2. From your remote control
 Briefly press the
 The remote control will then beep twice in confirmation
 The time delay starts, and short beeping sounds are emitted from the keypad and/or
remote internal sirens. At the end of the time delay the system enters part set
mode 1 or 2 depending on which button was pressed. The red light on the keypad
flashes every two seconds.
key on the keypad to wake it up
button and release after the first beep
button on the keypad then press the
AlARM ModE Sp1
> BAdGE oR CodE
or
or button and release after the first beep
or to confirm
SYSTEM
ARMING
button
to confirm
ARMING
Sp1
6