Toyota HIACE 2006 Owner's Manual page 50

-Fastening 3-point type seat
belts
Adjust the seat as needed and sit up
straight and well back in the seat. To
fasten your belt, pUll it out of the re-
tractor and insert the tab into the
buckle.
You will hear a click when the tab locks
into the buckle.
The seat belt length automatically adjusts
to your size and the seat position.
The retractor will lock the belt during a
sudden stop or on impact. It also may
lock if you lean forward too quickly. A
slow, easy motion will allow the belt to
extend, and you can move around freely.
If the seat belt cannot be pulled out of the
retractor, firmly pull the belt and release
it. You will then be able to smoothly pull
the belt out of the retractor.
&
CAUTION
• After inserting the tab, make sure
the tab and buckle are locked and
that the belt is not twisted.
• Do not insert coins, clips, etc. in
the buckle as this may prevent you
from properly latching the tab and
buckle.
• If the seat belt does not function
normally, immediately contact your
Toyota dealer. Do not use the seat
until the seat belt is fixed, because
it cannot protect an adult occupant
or your child from death or serious
injury.
Adjust the position of the lap and
shoulder belts.
Position the lap belt as low as possible
on your hips-not on your waist, then ad-
just it to a snug fit by pulling the shoulder
portion upward through the latch plate.
41