SymCom PumpSaver Plus 234-P Installation Instructions Manual page 7

7. After 2 seconds, the CAL. and RUN LIGHTS will blink once indicating line-side rapid-cycle
protection has been enabled.
RAPID CYCLING (Load Side / Downstream)
Load-side rapid cycling of the pump will immediately result in a manual lock-out. The pump will
n ot restart automatically. To reset the PumpSaver
Note: Protection against rapid cycling of a control device installed after the PumpSaver
always enabled. Disabling line-side detection will not disable load-side detection.
USING AN INFORMER
®
The PumpSaver
®
PumpSaver Plus Informer—a handheld, battery-operated, diagnostic tool. The Informer—when
directed at the PumpSaver
overcurrent trip points; calibration voltage; last 20 faults; voltage,; current and power at the last
fault; highest/lowest voltage and current since calibration; the model number; and the CT size if
applicable. The Informer can be used on any single-phase PumpSaver® equipped with an infrared
LED transmitter. Contact SymCom for more information at 800-843-8848 or visit our website:
www.symcom.com.
© 2009 SymCom, Inc. All Rights Reserved
Plus is equipped with an infrared LED that will communicate to a SymCom
®
Plus —will display real-time voltage, current and power; dry-well and
®
Plus, remove and re-apply power.
®
Plus is
7