5 Operation
5.1 Adjust in-feed Fence
To apply the edge on the panel correctly, it
is necessary to
the "Edging line". By "Edging line" we mean
the alignment of:
1.
In-feed fence B.
2. Pressure rollers.
3. Round bar of end trim unit.
4. Fence of flush trimming unit area.
•
Depending on the edge thickness to be
applied the thickness adjustment device
C must be positioned following the mm
thickness indicated C.
5.2 Adjustment to fit the Edge Thickness
1.
Check the thickness of edge.
2. Loose the fixed handle D and turn the
handle E to adjust the in-feed fence
3. Cut an edge which you are going to edge
on the fixed plate and lock the fixed
handle D.
•
The set measurement has to be exactly
the same as the thickness of the edge.
Note: Never Loosen four fixing screws A off
from the in-feed fence fixed plate.
keep the panel parallel to
16
5 Operation