Permanently Mounting The Hsm2Host And Wireless Devices; Deletingthe Hsm2Host - Johnson Controls Tyco HSM2HOST Installation Manual

Permanently mounting the HSM2HOST and wireless devices

Once you identify a suitable location to permanently mount the HSM2HOST and wireless devices,
complete the following steps:
1.
Pull the Corbus wires through the holes at the back of the HSM2HOST cabinet.
2.
Using a screwdriver, securely mount the HSM2HOST cabinet of to the wall using the three
screw supplied. For more information, see Figure 2.
3.
To install the wall tamper, securely attach the breakaway wall tamper bracket to the wall
using the screws supplied.
4.
Install the wireless devices. For more information, refer to the device's Installation Guide.
Figure 1:
Mounting the HSM2HOST
Deleting the HSM2HOST
To delete the HSM2HOST, complete the following steps:
1.
Using the keypad, enter Installer Programming section [902][106] (Delete HSM2HOSTx).
2.
Press [*] to delete.
- 9 -