Advertisement
Note: Framing dimensions in Figures 4 - 9 are calculated for a nailing flange depth of ¹⁄₂ " (13 mm).
Outside Wall
37" (940mm)
Figure 4
41"
(1041mm)
37" (940mm)
58 ¹ ₂" (1473mm)
Figure 5
Figure 6
The header may be in direct contact with the top
metal spacers, but must not rest on them or be
notched to fit around them.
Step 2. Route a ¹⁄₂" (13 mm) gas line along the
left or right side framing ( see Figure 10 ).
6
Outside Wall
15¹⁄₂"
(394mm)
CF5500
Figure 7
47 ⁷ ₈"
(1216mm)
13 ¹ ₂"
(343mm)
29"
(737mm)
CF5500
Figure 8
CF5500
Figure 9
All appliances have a 3" long ³⁄₈" NPT nipple
installed at the valve. To quickly and easily
complete the gas line routing, use the gas flex
line kit, Model GFLV.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE.
19 ¹⁄₂"
(495mm)
41" (1041mm)
CF6500
14 ¹ ₄"
(362mm)
33 ⁷₈"
(860mm)
41" (1041mm)
67 ³ ₄" (1721mm)
CF6500
CF6500
Figure 10
Step 3. Remove the nailing flanges from the
lower control compartment and install in place
with three (3) screws each. Align with the
three holes on each side of the appliance (see
Figure 11 ).
Figure 11
All units come complete from the factory with
an installed hood. Ensure that the hood is
installed. If required, position the hood in the
open area above the appliance door covering
the diverter baffles. Insert the tabs, on each end
of the hood, into the bracket at each end. Bend
the two tabs over to secure.
Step 4. Position appliance into prepared fram-
ing, secure with 6d nails at the nailing flange
along each side.
Step 5. Connecting Gas Line – Make gas line
connections. All codes require a shut-off valve
mounted in the supply line. Figure 12 illus-
trates two methods for connecting the gas
supply. Installation methods and materials
must be in compliance with local codes.
Nailing Flange
Advertisement
