Table of Contents
Advertisement
This manual contains important safety, installation instructions for the Zenith HydroTap G4.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
For products sold in Europe, this appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
Qualifications
If the power cable is damaged it must be repaired only by a qualified technician. To avoid hazards, all
installation procedures must be carried out by a suitably qualified tradesperson. The power cable and power
outlet must be in a safe visible position for connection.
Lifting
Take care when lifting the Zenith HydroTap unit. Some units may exceed safe lifting limits. If you feel this is
beyond your personal capabilities, please seek assistance with the lift. The weights of the units are marked
on the packaging. Do not lift the unit by the front cover or any connections at the top rear of the unit. Refer to
page 7 for the weight of your product.
Airflow
The ambient temperatures this unit should operate within are 5ºC - 35ºC. Proper air circulation must be
provided. The system will operate satisfactorily only if the recommended air gaps are provided. If a vent kit is
supplied it must be fitted. See technical specifications for correct installation to prevent overheating.
Positioning
It is important to ensure the undersink unit is positioned in an accessible area close to the floor level. The unit
must have it's base mounted in a horizontal position with all inlets and outlets facing up. The Tap must be
located above the undersink unit. See section 1.
not be cleaned by a water jet.
WARNINGS
The Zenith HydroTap unit must be earthed. The resistance of the earth connection from each exposed
1.
metal part must be less than 1 ohm.
All Installation and service work must be completed by trained and suitably qualified Tradespeople.
2.
Faulty operation due to unqualified persons working on this product, or any other Zenith product may
void warranty coverage.
All Plumbing must comply with AS/NZS3500.
3.
All Electrical must comply with AS/NZS3000
4.
All Plumbing and Electrical connections must be made in accordance with local regulations.
5.
This HydroTap product is rated for 230V 50Hz AC operation.
6.
Undersink units must never be located near, or cleaned with water jets.
7.
Zenith HydroTaps are not to be exposed to the elements of nature
8.
Due to the process of continuous improvement, Zenith Heaters reserves the right to change details
9.
mentioned in this manual, without notice.
Page 6 of 20
Important Safety Instructions
in an area that may be cleaned by a water jet and must
801525NZ - Chilled HydroTap Installation Instructions - Aug 2015 - v2.00
Advertisement
Table of Contents
