Table of Contents
Advertisement
When installing air flow ducts, the following tools will be required:
• Jigsaw and 12mm drill.
• Keyhole or Wall Board saw.
Recommended Installation showing the correct air flow
MIN.
35mm
Warm Air OUT
via kickboard louvre
2.1
All Models
Proper air circulation must be provided for all Chilled models. The system will operate correctly only if the
recommended air gaps are achieved during Installation. It is recommended to install vent duct and louvre
panels for under floor and /or door vent systems.
**Note: Inlet and outlet vents should be separated by a Min 100mm, to avoid hot air recirculation.
IMPORTANT: See page 13 for clearances.
Page 14 of 20
Section 2
Ventilation
**MIN.
100mm
801525NZ - Chilled HydroTap Installation Instructions - Aug 2015 - v2.00
Cool Air IN
via cabinet
floor, front
vent grille
Advertisement
Table of Contents
