Table of Contents
Advertisement
Undersink Unit Installation
3.1
Hose and tube fitting. (Do not overtighten)
• Remove all caps from the top of the undersink unit.
• Fit the foam insulation to the Blue tube after trimming to length.
• Install the mains water braided hoses to the undersink unit before locating the unit in place.
3.2
Model C125
Model C175
POWER
USB
CORD
Min
35 mm
Note: The tube lengths are matched to the pumps performance and therefore CANNOT be lengthened
Page 16 of 20
Section 3
BLUE
BRAIDED
CHILLED
OUTLET
336mm
801525NZ - Chilled HydroTap Installation Instructions - Aug 2015 - v2.00
tubes must be cut to size.
They must have a constant
MAINS
IN
MAX
1490 mm
MAX
400 mm
Note: All silicon
fall back to the unit.
Note:
- Mains hose
length is 750mm
- Plug and Cord
length is 1800mm
Position the under
sink unit close
to the outlet tap,
within reach of
the hose and cord
lengths supplied
Advertisement
Table of Contents
