Mazda CX-30 Manual page 306

When Driving
i-ACTIVSENSE
If cracks or damage caused by flying
gravel or debris is visible around a
rear radar and rear camera, stop
using the SBS-RC system
immediately and have your vehicle
inspected by an Authorized Mazda
Dealer. If the vehicle continues to be
driven with cracks or scratch marks
left around an ultrasonic sensor, the
system may operate unnecessarily
and cause an unexpected accident.
Refer to Stopping the Smart Brake
Support [Rear Crossing] (SBS-RC)
System Operation on page 4-164.
Consult an Authorized Mazda Dealer
for rear bumper removal.
Do not modify the suspension:
If the vehicle height or inclination is
changed, the SBS-RC system may not
operate correctly because it cannot
detect obstructions correctly.
Do not apply a strong force to a rear
radar and rear camera:
When washing the vehicle, do not
spray highly pressurized water against a
rear radar and rear camera, or rub it
strongly. In addition, do not hit the rear
bumper forcefully when loading and
unloading cargo. Otherwise, the
sensors may not detect obstructions
correctly which could cause the
SBS-RC system to not operate
normally, or it could operate
unnecessarily.
4-162
NOTE
The SBS-RC system will operate

under the following conditions.
The engine is running for 3 seconds

or more.
The shift lever (manual

transmission vehicle) or the
selector lever (automatic
transmission vehicle) is in the R
(reverse) position.
i-ACTIVSENSE warning indication/

warning light is not displayed in the
multi-information display.
The vehicle speed is under about

10 km/h (6 mph).
The vehicle speed of an

approaching vehicle is about 3
km/h (2 mph) or faster.
The SBS-R is not turned off.

The DSC is not malfunctioning.

In the following cases, the

i-ACTIVSENSE warning indication/
warning light turns on and operation
of the system is stopped. If the
i-ACTIVSENSE warning indication/
warning light remains illuminated,
have the vehicle inspected at an
Authorized Mazda Dealer as soon as
possible.
Some problem with the system

including the SBS-RC system.
A large deviation in the installation

position of a rear side radar sensor
on the vehicle has occurred.
There is a large accumulation of

snow or ice on the rear bumper
near a rear side radar sensor.
Driving on snow-covered roads for

long periods.
The temperature near the radar

sensors becomes extremely hot
due to driving for long periods on
slopes during the summer.
The battery voltage has decreased.
