Mazda CX-30 Manual page 243

1. The walls at the entrance and
exits of tunnels, turnouts.
A BSM warning indicator light may

flash or the warning beep may be
activated several times when making
a turn at a city intersection.
Turn off the BSM while pulling a

trailer or while an accessory such as a
bicycle carrier is installed to the rear
of the vehicle. Otherwise, the radar's
radio waves will be blocked causing
the system to not operate normally.
In the following cases, it may be

difficult to view the illumination/
flashing of the BSM warning
indicator lights equipped on the
door mirrors.
Snow or ice is adhering to the door

mirrors.
The front door glass is fogged or

covered in snow, frost or dirt.
The rear side radar sensor of the BSM

may be regulated under the radio
wave related laws of the country
where the vehicle is driven. If this
system is used abroad, it may be
necessary to turn off the system.
Refer to Rear Side Radar Sensor on
page 4-205.
The system switches to the Rear

Cross Traffic Alert (RCTA) function
when the shift lever (manual
transmission) or the selector lever
(automatic transmission) is shifted to
the reverse (R) position.
Refer to Rear Cross Traffic Alert
(RCTA) on page 4-115.
▼ Blind Spot Monitoring (BSM)
Warning Indicator Lights/Display
Indicator/Blind Spot Monitoring
(BSM) Warning Beep
The BSM system notifies the driver of
the presence of vehicles in adjacent
lanes or at the rear of the vehicle using
the BSM warning indicator light, the
warning sound and the display
indicator while the systems are
operational.
BSM warning indicator lights
The BSM warning indicator lights are
equipped on the left and right door
mirrors. The warning indicator lights
turn on when a vehicle approaching
from the rear in an adjacent lane is
detected.
When the ignition is switched ON, the
warning indicator light turns on
momentarily and then turns off after a
few seconds.
When Driving
i-ACTIVSENSE
4-99