IDEC WB1F Support Tool User Manual page 15

1 Overview
For Windows 8, 8.1/10
z
(1) Press the Windows key and the X key.
(2) Click Device Manager on the displayed menu.
(3) The Device Manager screen is displayed. Double-click Ports (COM & LPT).
(4) For the USB type, check the port number for the port that is displayed as "IDEC Auto-ID WB1F USB CDC (COM**)".
For the RS-232 type, check the port number for the port that the RS-232-to-USB conversion cable is connected
to. ** indicates the port number.
If the port number checked in "How to check the communication port" is not displayed in the commu-
nication port on the Connection Settings screen
Close the WB1F Support Tool, cycle the power supply to the WB1F, and then start the WB1F Support Tool again.
2
After you select the communication port, click Automatic connection.
3
After the connection is established, click Function - Control command on the menu bar. The Control Com-
mand screen is displayed.
4
4
Click Start reading and the WB1F enters the reading operation state for two seconds (emitter LED turns on).
Have the WB1F read an actual barcode at this time.
2 Operational Check
2-6
3 Screen and Menu
5
4 Appendix
Operation confirmation method