Table of Contents
Advertisement
ENG
1
2
3
Installing the Display on the Wall Attachment Panel
Check for the stability of the wall where the PDP is to be installed. If the wall is not enough strong to
support the PDP, strengthen the wall before installation.
Fix the wall attachment panel on the
wall using bolts as shown in the figure:
Fixing bolts must protrude from the
wall appox. 1.5 cm.
Using the wall attachment panel, you may adjust the angle of the display from 0 to 20 degrees. The
angle can be set in 5 stages with 5 degrees of distance each using the angle control holes on the sides
of the panel.
When the angle has
been set to 5 degrees.
Angle control holes
10
Wall attachment panel is sold separately. Check with your dealer
When the angle has
been set to 15 degrees.
5 degrees of tilt
10 degrees of tilt
15 degrees of tilt
No tilt
20 degrees of tilt
When the panel hasn't
been tilted.
Advertisement
Table of Contents
