Evaporator Fan - Traulsen TE Series Service Manual

STEP 1: Begin by removing the back cover by first
removing the four screws which secure this to
the cabinet (see illustration 1).
All evaporators and fans are located along the
back wall of the cabinet and best accessed
from the rear (see illustration 2).
STEP 2: Remove the holding rod and unhook the rod
from the other end. This evaporator fan can
then be lifted away from the assembly (see
illustration 3).
STEP 3: Disconnect the wires from the assembly.
STEP 4: Reverse the procedure to install the new

evaporator fan.

STEP 5: Reconnect power to the unit.
STEP 6: Reset the microprocessor control defrost time
settings to the correct time of the day.
IV. c - REPLACING THE EVAPORATOR FAN
WARNINGS:
1) DISCONNECT THE ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT/TAGOUT
PROCEDURES.
-8-
Illustration 01
Illustration 02
Illustration 03