3-10. Tft Board - Sony XAV-AX200 Service Manual

XAV-AX200/AX200C2

3-10. TFT BOARD

Note 1: Replaced old TFT board is destroyed with
the hammer, and throw out it.
6 Unlock the connector.
(CON2)
3 Unlock the
terminal
side
7 Draw the TFT FPC
out of the connector.
4 Draw the touch panel FPC
out of the connector.
qs Unlock the connector.
(CON8)
terminal side
qg screw
(PTT2.6 5)
qd Draw the FFC
(35 pin) out of
the connector.
hole
qa Draw the FFC (20 pin)
out of the connector.
terminal
9 Draw the FFC
side
(60 pin) out of
the connector.
qj TFT board
24
Note 2: When the TFT board is replaced, be sure to refer the following, and perform them.
front panel block
5 Peel off the
top side
connector.
(CON4)
terminal
side
rear side
hole
rib
8 Unlock the
connector.
(CON7)
qf screw
Note 3: When installing the TFT board,
align the two ribs and two holes.
• COMMUNICATION CHECK OF Apple CarPlay OR Android Auto (page 7)
• FLICKER ADJUSTMENT (page 25)
Note about installing the BT antenna cable connector
When installing the BT antenna cable connector,
insert vertically, and push it from the top.
OK
Insert vertically.
BT antenna cable
protect sheet.
connector
front side
1 filament tape
(sub material)
rib
qh Draw the BT antenna
cable out of the groove.
qf screw
(B2 8)
groove
How to install the flexible flat cable
Insert the flexible flat cable straight into the interior.
There is a possibility that using this unit without
the flexible flat cable correctly installed will damage it.
(B2 8)
OK
Insert straight into
the interior.
connector
flexible flat cable
NG
Insert at a slant.
BT antenna cable
connector
2 BT antenna cable
connector (CON9)
top side
CON9
screw
filament tape
(sub material)
Pass the BT antenna
cable beside the screw.
0 Unlock the connector.
(CON5)
terminal side
NG
Insert only part way. Insert at a slant.
connector connector
flexible flat cable flexible flat cable
TFT
board
groove
NG
SYS SET