Deleting Individual Button Codes (Delete Key) - Silvercrest SFB 10.1 C3 User Manual And Service Information

SilverCrest SFB 10.1 C3
7. Place the original remote control so its IR LED and the IR LED (2) of
your 10-in-1 remote control face each other and are no greater than
5 cm apart.
8. Next press the button on the original remote control from which you
wish to copy the signal. The successful detection of the button code is
indicated by "SUCCESS" on the display.
9. Repeat steps 5 to 8 for each button that you wish to learn a function.
10. If the transmission of the original code fails or no code is sent during
the next 30 seconds, "FAIL" appears on the display. In this case,
repeat steps 5 to 8.
You can quit learning mode by pressing the
reads "SELECT KEY". Pressing any of the device buttons takes you back
to the start window.
If you experience any problems with the learn function, the
batteries of the original remote control could be low.
Replace them if necessary.

Deleting individual button codes (DELETE KEY)

This function allows you to delete the learned code for an individual
button for a selected device.
1. Press the device button for the device that you wish to program.
2. Press and hold the
3. Press
4. Press
5. The display reads "SELECT KEY".
6. Press the button for which you want to delete the code. The display
reads "SURE DELET".
7. Press
"SELECT KEY".
8. Repeat steps 6 and 7 for each button for which you wish to delete
the code.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
60 - English
, select "LEARNING" and press
, select "DELETE KEY" and press
to confirm. The display reads "DELETED" and then again
button for 3 seconds.
button if the display
to confirm.
to confirm.