Table of Contents
Advertisement
WCM802/900
European Compliance (2.4 GHz only)
The WCM802 has been certified for use in several European countries.
If the WCM802 Modules are incorporated into a product, the manufacturer must ensure
compliance of the final product to the European harmonized EMC and low-voltage/safety
standards. A Declaration of Conformity must be issued for each of these standards and kept on
file as described in Annex II of the R&TTE Directive. Furthermore, the manufacturer must
maintain a copy of the WCM802 user manual documentation and ensure the final product does
not exceed the specified power ratings, antenna specifications, and/or installation requirements
as specified in the user manual. If any of these specifications are exceeded in the final product, a
submission must be made to a notified body for compliance testing to all required standards.
OEM Labeling Requirements
The 'CE' marking must be affixed to a visible location on the OEM product.
Figure A.3.
The CE mark shall consist of the initials "CE" taking the following form:
Furthermore, since the usage of the 2400 – 2483.5 MHz band is not harmonized throughout
Europe, the Restriction sign must be placed to the right of the 'CE' marking as shown below. See
the R&TTE Directive, Article 12 and Annex VII for more information
Figure A.4.
Restrictions
France – France imposes restrictions on the 2.4 GHz band. Go to www.art-telecom.Fr or contact
Horner for more information.
Norway – Norway prohibits operation near Ny-Alesund in Svalbard. More information can be
found at the Norway Posts and Telecommunications site (www.npt.no).
WCM802 Declarations of Conformity
Horner has issued Declarations of Conformity for the WCM802 Modules concerning emissions,
EMC and safety. Files are located in the 'documentation' folder of the Horner CD.
Important Note
Horner does not list the entire set of standards that must be met for each country. Horner
customers assume full responsibility for learning and meeting the required guidelines for each
country in their distribution market. For more information relating to European compliance of an
OEM product incorporating the WCM802 Module, contact Horner (see Appendix B), or refer to the
following web sites:
CEPT ERC 70-03E – Technical Requirements, European restrictions and general requirements:
Available at www.ero.dk/
R&TTE Directive – Equipment requirements, placement on market: Available at
20 JUN 2005
CE Labeling Requirements
• If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
• The CE marking must have a height of at least 5mm except where this is not possible on
account of the nature of the apparatus.
• The CE marking must be affixed visibly, legibly, and indelibly.
CE Label Required on OEM Equipment
PAGE 37
>5
(Taller than 5 mm)
www.ero.dk/
Advertisement
Table of Contents
