Table of Contents
Advertisement
PAGE 6
CHAPTER 1: SAFETY / COMPLIANCE
1.1
Safety Warnings and Guidelines
When found on the product, the following symbols specify:
Warning: Consult user documentation.
WARNING: This equipment is approved only for mobile and base station transmitting devices.
Antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 30 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
NOTE: The separation distance indicated in the above is 30 cm, but any distance greater than
or equal to 23 cm can be used (per MPE evaluation).
WARNING: To avoid the risk of electric shock or burns, always connect the safety (or earth)
ground before making any other connections.
WARNING: To reduce the risk of fire, electrical shock, or physical injury it is strongly
recommended to fuse the voltage measurement inputs. Be sure to locate fuses as close to the
source as possible.
WARNING: Replace fuse with the same type and rating to provide protection against risk of
fire and shock hazards.
WARNING: In the event of repeated failure, do not replace the fuse again as a repeated failure
indicates a defective condition that will not clear by replacing the fuse.
WARNING: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, or service this
equipment. Read and understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in severe bodily injury or
loss of life.
All applicable codes and standards need to be followed in the installation of this product.
•
For I/O wiring (discrete), use the following wire type or equivalent: Belden 9918, 18 AWG
•
or larger.
Adhere to the following safety precautions whenever any type of connection is made to the
module.
Connect the green safety (earth) ground first before making any other connections.
•
When connecting to electric circuits or pulse-initiating equipment, open their related
•
breakers. Do not make connections to live power lines.
Make connections to the module first; then connect to the circuit to be monitored.
•
Route power wires in a safe manner in accordance with good practice and local codes.
•
Wear proper personal protective equipment including safety glasses and insulated gloves
•
when making connections to power circuits.
Ensure hands, shoes, and floor are dry before making any connection to a power line.
•
19 MAR 2007
MAN0943-01
Warning: Electrical Shock Hazard.
Advertisement
Table of Contents
