Worx WR165E Owner's Manual page 17

MESSAGE CAUSE
Wheels motor fault! Wheel motor is blocked in
Press START to reset. some way.
Upside down! Press This could have happened
START to reset. when Landroid came into
contact with a sloping
surface which made it
overturn.
Mower trapped! Press Landroid is trapped.
START to reset.
Mower lifted! Press Landroid is lifted up.
START to reset.
Battery voltage too Battery exausted.
low! Please change
battery.
Wire missing! Press Machine can't find
START to reset. boundary wire signal.
Battery temperature Temperature is too high
out of range! (more than 55
Please wait. low(less than 0
charging.
Can't find charge Boundary wire is beyond
station press START its maximum length (300m
to reset. or machine doesn't have
enough power to go back
to charging station.
Mower locked! With the 'Lock Function'
enabled, if your Landroid
does not receive a signal
from your Wi-Fi router for 3
days, then it gets locked as
a security measure.
This could be because
your router lost its power or
because you changed your
Wi-Fi router or network
provider.
16
ACTION
Turn power off and take Landroid to an area free from obstacles.
Turn power on. Press start.
If the error message is still displayed, turn power off. Turn Landroid
upside-down and check if there's anything preventing the wheels from
rotating.
Remove any obstruction, turn Landroid upright, turn power on.
Turn Landroid upright and remove any obstacle that might have caused
Landroid to overturn.
Turn power off.
Take Landroid to an area of your lawn free of obstacles, then turn power
on. Press start.
If the error message is still displayed: turn power off, turn Landroid
upside-down. Check if there is anything preventing the wheels from
rotating.
Remove any obstruction, turn the Landroid upright, turn power on.
Turn power off.
Take Landroid to an area clear of obstacles, turn power on. Press start.
If the error message is still displayed: turn power off, turn Landroid
upside-down and check there's anything that can cause Landroid to be
lifted up.
Remove any possible object, turn Landroid upright, turn power on.
In this case you must turn Landroid off and place it in the charging
station, then 'Emergency charging' will be displayed and it will start
charging. If the battery error still persist, your battery is damaged and
need to be changed.
If the LED light is red, check if the boundary wire is well connected to the
clamps on the charging pile.
If the problem persists, check that the boundary wire hasn't been cut.
Place the charging station in a shady area or wait until it reaches the
C)or too normal temperature.
0
C) when
0
Take Landroid to the charging station.
Please reconnect Landroid to the Wi-Fi networtk it has been originally
paired with. If this is not possible, contact Cutomer Service.
EN