Securefast SBL300 Troubleshooting Manual page 10

The lever of my SBL365 always operates how do I lock it?

The lever will always be operable as there is a clutch within the handle that allows this to take
place to try and prevent the unit from sustaining damage if forced or vandalised without
inputting of the programmed code.
When I enter the correct code on my SBL365.S with latch or SBL365.SL with mortice lock case it
does not withdraw the latch when I operate the handle.

Check the spindle has been rotated appropriately according to the handing of the door. Whilst
looking at the reverse of the digital lock rotate the spindle fully anti-clockwise for left handed
applications and fully clockwise for right-handed applications before locating in to the follower
of the lock/latch and securing the unit to the door.

Is the correct code being input? Remove the SBL365 from the door and look at the dials on the
back to ensure you have the correct code.
Easy Code Plus Mechanical Digital Lock
General Questions - SBL700
When I enter the correct code on my SBL700 unit it does not withdraw the
latch when I operate the knob.

Check the spindle has been rotated appropriately according to the
handing of the door. Whilst looking at the reverse of the digital lock rotate
the spindle fully anti-clockwise for left handed applications and fully
clockwise for right-handed applications before locating in to the follower
of the lock/latch and securing the unit to the door.

Is the correct code being input? Remove the SBL700 from the door; look at
the reverse of the Digital Keypad Side. You will notice numbers corresponding with the buttons
on the front of the unit. Next to each number there is a hole. If you press 'C' then look in each
one, those holes which have a red marking in will be your programmed code.
How do I assemble my spindle on the SBL700.S?

Feed the radius end of the spindle through the collar and secure by
putting the supplied pin through the hole in the spindle. Remove the 3
screws, securing the plate that covers the cam, on the reverse of the
outside unit where the spindle locates and place spindle assembly in and
then re-secure the fixing plate
Mechanical Digital Locks
10 of 11