• Language independent
• Simple configuration via the backlit display
• Input for an external setpoint device
CMF
CMF10 is a pre-programmed controller that can be used
for control of temperature, CO
in air handling and heating applications. It is a stand-alone
controller for simpler applications. CMF is extremely easy
to install, commission and control.
CMF uses a display with an encoder knob, making
its built-in menu system very easy to use. Settings
are entered by turning the encoder knob to a desired
parameter/value. A value is then approved by pressing the
knob.
Models
The CMF series comprises two different types, CMF5U
and CMF10.
CMF5U has 5 in-/outputs and CMF10 has 10 in-/outputs.
CMF10 is available in two versions:
• CMF10 with 24 V AC supply voltage
• CMF10-230 with 230 V AC supply voltage
CMF has been developed according to our Ready-Steady-
Go concept, which simplifies every step from installation to
management.
CMF10
, pressure, and humidity
2
CMF10
Pre-programmed, configurable controller for
simple applications
The CMF10 range of controllers can be set to handle
everything from temperature or humidity control to
control of CO
or pressure. They are intended for DIN-
2
rail mounting.
• Pre-loaded with several application modes
• 24 V or 230 V AC supply voltage
• Week-based clock / calendar function
Applications CMF10 and CMF10-230
CMF10 is pre-programmed with a choice of five different
control modes:
1. Supply air control
2. Supply air control with outdoor compensation
3. Cascaded room / extract air temperature control
4. Radiator circuit control
5. Domestic hot water control
Inputs and outputs
CMF10 has
• 2 analogue inputs, PT1000
• 1 SPI input for an external setpoint device
• 1 universal input, PT1000 or digital
• 2 digital inputs
• 3 digital outputs
• 2 analogue outputs, 0...10 V DC
Internal clock
CMF10 has a built-in week-based real-time clock with a
number of different scheduler alternatives.
Easy to install
CMF is suitable for DIN-rail or cabinet mounting. Since
the terminals are detachable all connections can be made
before CMF is installed.
revision
10 2015