Maintenance And Cleaning; Bearings; Height Adjustment And Joints; Belt Drive - Bartell Global CONTEC CT250 Owner's Manual And Parts Book

OIPB – C15009
CT250 FLOOR PLANER/SCARIFIER
OWNER'S MANUAL AND PARTS BOOK
If the drum has to be adjusted proceed as follows: Place the planer on an even floor. Lift the machine
with the height adjustment hand wheel, until all the tools are well clear of the floor. Loosen the
clamping screw of the eccentric shaft. On the other side of the rear wheel is a screw which keeps the
wheel on the shaft. Turning the screw will also turn the eccentric shaft. The floor planer moves up
and down on one side. Always turn the screw clockwise. Anti clockwise would loosens the screw.
Keep turning until all the tools on the drum are the same distance to the floor. Tighten the clamping
screw again.

8. Maintenance and cleaning

8.1 Bearings

All bearings are greased for their life time.

8.2 Height adjustment and joints

All joints have to be greased periodically with a standard machine grease.

8.3 Belt drive

Check the belt after approximately every 30 hours of operation. For tensioning the belt you need to
change the position of the belt tensioner wheel underneath the belt cover.

8.4 Cleaning

Regular cleaning of the machine increases the life of all components and tools of the planer.
6