Advertisement
Step 6 Fan Blade and Blade Arm Assembly
Most CONCORD fans are supplied with a
reversible blade finish. Choose the blade finish
that you prefer and attach as follow:
Attach each fan blade to a blade arm with
three 3/16" x 7.5 mm blade screws and three
3/16" fiber washers (see figure 11). DO NOT
OVER TIGHEN THESE SCREWS.
Screws should be tightened until the washers
are compressed by the screw head. Hold the
Blade Arm decorative side down and place
the blade on top with the flat side of the blade
facing down. Each screw is passed through
the washer and blade and screwed into the
blade arm.
Step 7 Fan Blade Assembly Installation
Remove the large screws in the face of the motor.
Discard any rubber blocks attached to these
screws. The rubber blocks are installed at the
factory to stabilize the motor during shipment.
Attach each blade to the motor face using pre-
installed screws
bend the blade arms during installation. This
will cause your fan to wobble while running.
Try mounting the blades on
opposing sides of the motor
face, This will help keep the
fan more level during blade
installation.
8
. Take care not to
Blade to Arm Screws
Blade Arm
Fan Blade
Fig. 11
Motor Housing
Blade to Arm Screws
Blade Arm
Fan Blade
Blade Arm to Motor screws
Fig. 12
Advertisement
