Preparation; Use - Bosch VitaMaxx MMBV6 Series Instruction Manual

Lid with vacuum seal
For an air-tight seal on the blender jug,
ToGo bottle and storage containers. To
remove a lid with vacuum applied, first
grip the vacuum seal at one end and pull
it up. Sufficient air has to get inside for the
lid to be removed. The lids of the storage
containers are equipped with a date
indicator. Turn the two rings to set the day
and month when the food was added.
Safety systems
The appliance has various safety systems.
X "Safety systems" see page 25

Preparation

W Risk of injury
– Do not reach into the blender knife. Grip
the blade insert by the plastic only.
– Do not insert the mains plug until
all preparations for working with the
appliance are complete and the blender
jug has been correctly positioned on the
base unit.
Warning!
When the blender is assembled, do not lift
it by the handle of the blender jug. To lift
the blender, always grip it by the base unit/
motor block.
X Image sequence B
1. Unwind the power cord to the required
length.
Important: Make sure that the power cord
runs through the cable opening on the
underside of the appliance.
2. Place the base unit on a stable and level
work surface. Open the cap completely.
3. Turn the blender jug upside down and fit
the blade insert with the sealing ring in it
as shown.
4. Fit the lid of the blender jug onto the
blade insert.
5. Rotate the blade insert clockwise to the
stop with the help of the lid.
6. Remove the lid.
Important: The recesses on the blade
insert must be aligned with those on the
blender jug.
7. Turn the blender jug up the right way
and position on the drive as shown.
Marking pointing to
8. Rotate the blender jug clockwise to the
stop. Marking
9. Prepare the food and add to the blender
jug. Do not exceed the marking
Note: Always blend food with sufficient
liquid as this will produce a better result.
When adding ingredients liable to froth up
such as milk and dairy products, do not
exceed the marking
10. Fit the lid and press on firmly. Observe
the recess on the handle when doing so.
Note: The lid can only be fitted in this
position.
11. Close the cap and press down to the
stop.
12. Insert the mains plug.
Note: The blender can only be used if the
following conditions are met.
– The blade insert and lid must be
properly connected to the blender jug.
– The blender jug must be properly
connected to the base unit.
– The cap must be completely closed.

Use

Note: Table K shows further examples
of application. The preparation can be
carried out with an automatic programme or
manually in single steps (1, 2, 3).
Usage informations:
– This appliance is not suitable for making
mayonnaise.
– This appliance is not suitable for
cutting and chopping semi-solid or
solid food (parsley, onion, meat, nuts,
parmesan cheese), but could be used in
combination with liquids. X Table K
– This appliance is not suitable for
making nuts spreads (hazelnut cream,
nutella, ...).
Preparation
.
pointing to .
.
en
.
21