Cleaning And Maintenance - Bosch VitaMaxx MMBV6 Series Instruction Manual

2. Set the rotary selector to the required
level or . The symbol
The higher the speed, the more status
display LEDs are lit.
Note: During processing hold the blender
securely by putting one hand on the cap.
3. Process the ingredients until the desired
consistency is achieved.
4. Set the rotary selector to 0. Wait until
the appliance comes to a standstill.
5. Switch off the appliance using
Disconnect the mains plug.
6. Open the cap completely.
7. Turn the blender jug anticlockwise and
remove.
8. Pull the lid by the lug to remove. Pour
the blended food into another container.
■ Clean all parts. X "Cleaning and
maintenance" see page 23
Making crushed ice
Prepare the blender as described and add
ice cubes. X "Preparation" see page 21
■ Set the rotary selector to 0. Switch on
the appliance with
■ Press button. The symbol
up.
■ The blender automatically starts
processing and crushes the ice cubes
in a pulsing rhythm. The status display
LEDs light up one by one.
■ The blender ends processing
automatically. Wait until the appliance
comes to a standstill.
■ Switch off the appliance using
Disconnect the mains plug.
■ Perform steps from 8. as described.
X "Blending with automatic
programme" see page 22
Storage with vacuum
A vacuum can be applied to the ToGo bottle
and storage containers with the blender to
preserve the freshness and extend the shelf
life of food contained in them.
W Warning!
No antibacterial effect results from vacuum
application. Keep such food in the refrigerator
and regularly check that it is still fresh!
lights up.
button.
button.
lights
button.

Cleaning and maintenance

X Image sequence F
1. Add prepared or cooked food to the
container required.
2. ToGo bottle: Fit the lid with the drinking
cap and close securely. Fold up the lid.
3. Containers: Fit the lid and close
securely. Set the date using the two
rings on the lid.
4. Open the cap completely.
5. Fit the vacuum hose onto the vacuum
valve.
6. Close the cap. Fit the hose onto the
ToGo bottle or the lid of the container.
7. Set the rotary selector to 0. Switch on
the appliance with
8. Press
9. The vacuum pump draws the air out of
the container. The
The status display LEDs light up one by
one.
Note: If the preset vacuum level is
not reached, the
up and 2 short signal tones sound.
X "Troubleshooting" see page 27
10. All status display LEDs are lit. The
preset vacuum level is reached.
11. Switch off the appliance using
Disconnect the mains plug.
12. Remove the hose from the ToGo bottle
or container. Hold the cap securely and
remove the hose from the vacuum valve.
■ Grip the vacuum seal at one end and
pull it up. Sufficient air has to get inside
the blender jug for the lid to be removed.
■ Open the drinking cap or lid.
Cleaning and maintenance
The appliance and the individual parts used
must be thoroughly cleaned after each use.
W Risk of electric shock!
– Unplug the appliance before cleaning it.
– Never immerse the base unit in liquids
and do not clean it in the dishwasher.
– Do not use a steam cleaner.
W Risk of injury!
Do not touch the blender knife with your
bare hands. Use a brush.
button.
button.
symbol lights up.
symbol then lights
button.
en
23