Set Up Your Kitebarp - F-One Freeride Series User Manual

INFLATE YOUR KITE SET UP YOUR KITEBAR
1. Unroll your lines upwind from your kite (walking up towards the wind).
2. Put down the bar on the ground facing up with the red line on the left, the green one on
the right.
3. Untangle your lines as you walk towards your kite keeping the grey lines in the middle,
1 2 red line to the left and green line to the right.
4. Make sure that your bridle is clear and untangled.
.
5. Connect the front lines to the grey connectors (pig tails) on the bridle. You can tie any
VENT
of the front lines on the left and right side of the bridle. A lark's head knot will enable you to
connect the pig tails to the front lines. (see box about lark's head knot)
6. Connect your back lines (green and red) to the connectors on the kite tips. Red line
should be tied to the red connector and green line should be tied to the green connector.
Lark's head knots will enable you to tie the lines to the connectors. (see box about lark's
head knots) Make sure that your back and front lines not cross each others.
3 4
5 6
WIND
28 29
www.f-onekites.com www.f-onekites.com