Glamox FL60A Operating Instructions Manual page 42

de
en
fr
tr
el
es
pt
da
nl
no
sv
pl
cs
hu
Seite 16 von 26
In case of a star network, the floodlight must be connected to the power supply
as follows:

L = Phase

N = Neutral conductor

PE = Protective earth conductor - clamping points (3)
In case of a delta network, the floodlight must be connected to the power supply
as follows:

L1 = Phase

L2 = Neutral conductor

PE = Protective earth conductor - clamping points (3)
Max. 1 conductor each can be connected to the clamping points (1) to (3). The
connection terminal is suitable for the following line cross-sections:

Flexible lines without wire end sleeve

Rigid lines
The following clamping points are also available for additional use, if need be:

PE = Protective earth conductor - clamping points (4)
Max. 1 conductor each can be connected to the clamping points (4). The connec-
tion terminal is suitable for the following line cross-sections:

Flexible lines without wire end sleeves

Rigid lines
The modules are connected to the clamping points (5) or the clamping points
remain free.
TL65A:
Figure 6 Terminal block TL65A . . . .
The light must be connected to the power supply corresponding to the marking in
the connection socket.
- clamping points (1)
- clamping points (2)
- clamping points (1)
- clamping points (2)
0,5 bis 10,0 mm²
0,5 bis 10,0 mm²
0,5 bis 16,0 mm²
0,5 bis 16,0 mm²
02.12.2014 7179763200 / Index 00 / DCN 21433