Command Verification; Commands; Switch Port Command - ATEN HDMI VM0202H User Manual

Command Verification

After entering a command, a verification message appears at the end of the
command line as follows:
 Command OK - indicates that the command is correct and successfully
performed by the switch
 Command incorrect - indicates that the command has the wrong format
and/or values.

Commands

After connecting to the VM0202H / VM0202HB via Telnet or RS-232, you can
operate the system using the following commands.

Switch Port Command

The Switch Port command allows you to switch ports on the VM0202H /
VM0202HB.
The formula for the Switch command is as follows:
Command + Input + Number + Output + Number + Control + [Enter]
1. For example, to switch input port 02 (audio and video) to output port 01,
type:
sw i02 o01 [Enter]
2. To turn off video and audio output on port 02, type:
sw o02 off [Enter]
3. To switch the next output to port 02, type:
sw i02 + [Enter]
The following tables show the possible values for the Switch Port command:
Command
Input Command
Port number
sw Switch command
i Input command
xx 01-02 port (default is 01)
Chapter 4. RS-232 Operation
Description
Description
Description
23