Commissioning - Conrad Electronic GX106 Operating Instructions Manual

USB
The GSM module is connected with the PC with the enclosed USB cable
at this connection (no. 10).
LEDs
Once the module is booked into the GSM net, the green LED blinks
approx. every 3 seconds (no. 11).
The red LEDs light up when the corresponding output is activated.
OPERATING VOLTAGE
A direct voltage of 5 to 30 V/DC is connected to the input clamp (no. 1).
Observe the polarity.
If the module no longer reacts (e.g. with strong EMV impulses, electro-
static discharge or similar), the module must be disconnected from the
operating voltage and re-connected.
Initial operation
The module may only be commissioned after it has been
installed contact-free in a casing.
Prior to commissioning the module group, check whether it is suit-
ed for the intended application!
In case of doubt, you must contact an expert or the manufacturer!
33