Operation - Makita DHK180 Instruction Manual

Fig.12
Removing or installing the hook
To remove the hook, loosen the screws and remove the
washers and hook. To install the hook, insert the wash-
ers to the slits on the tool housing, and then secure the
hook with 2 screws.
3
Fig.13
► 1 . Hook 2. Screw 3. Washer
Connecting lanyard (tether strap) to
the hook
CAUTION:
Do not use damaged hook and
screws. Before use, always check for damages,
cracks or deformations, and make sure that the
screws are tightened.
CAUTION:
Install or remove the hook on a
stable table or surface. Be sure to use the screws
provided with the hook only. After installing
the hook, make sure that the hook is securely
installed with the screws.
CAUTION:
Do not remove the battery car-
tridge while hanging the tool. The tool may fall if the
screws are not tightened.
CAUTION:
Always use a locking carabiner
(multi-action and screw gate type) and be sure
to attach the lanyard (tether strap) to the double
looped portion of the hook. Improper attachment
may cause tool drop from the hook and result in
personal injury.
The hook is also used for connecting the lanyard (tether
strap). Be sure to connect the lanyard (tether strap) to
the double looped portion of the hook.
1
Fig.14
► 1 . Double looped portion of the hook 2. Lanyard
(tether strap) 3. Locking carabiner (multi-action and
screw gate type)
1

OPERATION

CAUTION:
both hands during operations.
CAUTION:
2
piece is secured before operation.
CAUTION:
even the bit gets stuck. Loss of control may
cause injury.
NOTE: If the battery cartridge is in low temperature,
the tool's capability may not be fully obtained. In this
case, warm up the battery cartridge by using the
tool with no load for a while to fully obtain the tool's
capability.
Hold the tool firmly with both hands. Turn the tool on
and apply slight pressure on the tool so that the tool will
not bounce around, uncontrolled. Pressing very hard on
the tool will not increase the efficiency.
Fig.15
9 ENGLISH
2
3
Always hold the tool firmly with
Always make sure that the work-
Do not pull the tool out forcibly