Safety Instructions - Festool C 12 Li Original Operating Manual And Spare Parts List

Charger
Mains voltage (input)
Mains frequency
Charging voltage (output)
Rapid charging
Conservation charging current, pulsating (only NiCd, NiHM)
Charging times for
Permitted charging temperature range
Temperature monitoring
Battery pack
Voltage
Capacity
Weight
* Speed specifications with fully charged battery pack.
** The maximum speed is reduced in the lower torque stages.
5

Safety instructions

5.1 General safety instructions
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future ref-
erence.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
5.2 Machine-related safety instructions
– Hold power tool by insulated gripping surfaces,
when performing an operation where the cut-
ting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live"
wire may make exposed metal parts of the power
tool "live" and could give the operator an electric
shock.
– The charger and power tool are not intended for
use by persons (including children) with limited
physical, sensory or mental ability or without
sufficient experience and/or knowledge, unless
they are supervised by a person responsible for
their safety or have been instructed on how the
charger or power tool is to be used.Children
should always be supervised to ensure that they
do not play with the charger or the power tools.
LiIon 1.5 Ah/ 3.0 Ah, 80 %
LiIon 1.5 Ah/ 3.0 Ah, 100 %
BPC 12 Li
10,8 V
1,5 Ah
0,31 kg
– Switch of the power tool immediately if the tool
is blocked. Always be prepared for high reaction
torques that can cause kickback.
The tool blocks if:
- the power tool is overloaded or - it becomes
jammed in the workpiece being processed.
– Wait until the power tool stops completely until
placing it down. The tool can become entangled
and lead to a loss of control of the power tool.
– Avoid unintentional activation. Ensure that the
on/off switch is in switched-off position before
inserting a battery. Carrying the power tool with
your finger at the on/off switch, or inserting the
battery when the power tool is switched on, can
result in accidents.
– Take care when drilling into walls as there is a
danger of rupturing concealed gas/water pipes
or cutting through power cables.
– Do not open the battery pack or the charger. Even
after disconnection from the mains, there is still
a high capacitor voltage inside the charger.
– Make sure that metal objects (such as metal
chips) or fluids do not enter the machine through
the battery pack retaining slots (danger of short
circuit).
– Do not charge battery packs from other manu-
facturers. The charger is designed for charging
original battery packs only. Never charge the bat-
tery packs in chargers from other manufactur-
ers. Otherwise there is a danger of fire and
explosion.
C 12 Li, C 15 Li
GB
TRC 3
220 - 240 V ~
50/60 Hz
7.2 - 18 V=
max. 3 A
approx. 0.06 A
approx. 25/ 55 min
approx. 35/ 70 min
-5 °C to +45 °C
via NTC resistor
BPC 15 Li
14,4 V
3,0 Ah
0,58 kg
13