Mitsubishi FR-A800 Series Manual page 77

7.2.2.2 Controller Settings of Screen Design Software
GOT NET No.
GOT Station No.
GOT Communication Port No.
Retry (Times)
Startup Time (Sec)
Timeout Time (Sec)
Delay Time (ms)
GOT Ethernet Settings
Update GOT Ethernet Standard Port
Setting
GOT IP Address
Subnet Mask
Default Gateway
Peripheral S/W Communication Port No.
Transparent Port No.
7.2.3 Ethernet Controller Settings of Screen Design Software
Host Net No.
1
1 *
*1: Change the models according to the CPU in use.
QCPU: QnUD(P)V/QnUDE(H)
LCPU : LCPU
7.2.4 Routing Information Settings
Routing information settings is required in order to connect to a different network. Set as below.
Transfer Net No.
CH1
7.2.5 PLC Side Settings (GX Works3)
(1) Go to [Parameter] - [Module Information] and add RJ71GF11-T2.
Set the station type and network number in [RJ71GF11-T2] - [Module Parameter] - [Required Settings] –
[Station Type].
Item
Station Type
Network No.
(2) Set the network configuration under [Parameter] - [Module Information] - [RJ71GF11-T2] –
[Module Parameter] - [Basic Settings] - [Network Configuration Settings]*1.
*1: For QCPU and LCPU, go to [Parameter] - [Network Parameter (Ethernet/CC IE Field)] in GX Works2 and add
CC IE Field (Master Station) to the module 1, and apply the settings above under [CC IE Field Configuration
Setting].
For detail, please refer to the user's manual of the devices in use.
Item
Item
Station Unit Type
1 RCPU *1
2
Set Value
1
18
5001
3
3
3
0
Set Value
Checked
192.168.3.18
255.255.255.0
0.0.0.0
5015
5014
IP Address
192.168.3.39
Relay Net No.
1
Set Value
Master Station
2
77/83
Remarks
Remarks
Port No. Communication
5006
UDP
Relay Station No.
1
Remarks
BCN-P5999-1045-1a